Re: Sierra-2 Upgrade instructions with video!
Originally Posted by
eliwankenobi
Hello!
I hope DaveF or somebody from Ascend can answer this.
Is there a specific torque specification for tightening the screws?
I see in the video that the screws are tightened with a torque screw driver and also have one and would like what would be the specific in-lb setting so as to get them as close to factory as possible..
Thanks
I don't think they actually have a set torque rating for this. It is more of a "feel" type of thing. Hand-tightened until it is snug enough that you would have to apply significant force to tighten further. If you use a drill/driver with an adjustable torque dial I'd use maybe a -2 or -3 setting and let it drive the screws in until it clicks for a few seconds.
Ed
* Sierra-2EX's W/V2 crossover upgrade
* (2) Rythmik F12's
* Parasound Halo P6
* Audio by Van Alstine DVA-M225 Monoblock Amps
* MiniDSP 2x4HD For Sub calibration
*World's Best Cables Canare 4S11 speaker cables