Hi guys,
Will my current receiver (Sherwood RX-4503) be good to power the Siera Towers?
|
Hi guys,
Will my current receiver (Sherwood RX-4503) be good to power the Siera Towers?
100 wpc rms should easily be enough, considering it is only 2 channels needing to be driven. The amps psu should have quite a reserve on top of the minimum watts needed which is only 25w per speaker (having additional channels would simply require more from the psu, lessening the available power from what's typically advertised down to 90/80/70/60wpc etc). Being as they're 92db in room sensitivity (the same as the CMT-340 SE), they'll essentially give out more volume wise than they take to power (comparing to lower sensitivity speakers).
All in all, should be absolutely no problems at any volume level.
Last edited by choirbass; 10-05-2012 at 11:21 PM.
Sierra 2 Front LR PA-1 DC-1
Sierra Luna Surround LR Multichannel via UMC-1 Stereo amp via VSX-D912 AVR
DC-1 Ext 2 Ch DAC LR XLR to Mono Amps LR RCA to UMC-1 Opt
T2531 31 Band Stereo Graphic EQ XLR RCA
PA-1 LR XLR Mono Block 140Watt @ 8 Ohms Class D Amps
UMC-1 Line Stage Sub X-over @ 40Hz
L12 12" Subwoofer RCA
P3 Power Plant A/C Regenerator - Can dramatically improve sound quality realism after 350 hours or 2 weeks of cumulative burn in
40" HDR 4K TV Opt
Windows 11 Gaming HTPC HDMI
D2R
Thanks, choirbass.
It's good to know that I can hang on to my Sherwood some more. I presently have 340SEs for mains mated to two 12-inch subs.
Actually I am debating between upgrading my receiver and upgrading my speakers. Knowing what I have right now, if you were me, which direction will you go? Upgrade receiver or upgrade speaker?
Thanks again,
Daniel
Choosing between the 2, either amps or speakers IMO goes to the speakers more hands down, as they'll simply provide the most obvious difference.
If you do opt for the towers, then using the 340se's as surrounds could always be an option later on, too.
Sierra 2 Front LR PA-1 DC-1
Sierra Luna Surround LR Multichannel via UMC-1 Stereo amp via VSX-D912 AVR
DC-1 Ext 2 Ch DAC LR XLR to Mono Amps LR RCA to UMC-1 Opt
T2531 31 Band Stereo Graphic EQ XLR RCA
PA-1 LR XLR Mono Block 140Watt @ 8 Ohms Class D Amps
UMC-1 Line Stage Sub X-over @ 40Hz
L12 12" Subwoofer RCA
P3 Power Plant A/C Regenerator - Can dramatically improve sound quality realism after 350 hours or 2 weeks of cumulative burn in
40" HDR 4K TV Opt
Windows 11 Gaming HTPC HDMI
D2R