Appreciate the feedback, I will work on a diagram for the dampener installation - that should help a lot.
|
Appreciate the feedback, I will work on a diagram for the dampener installation - that should help a lot.
When I texted my wife whose a dr, if we had any hemostats laying around the house, she panicked and assumed I was bleeding!
But all's good -- no damage to speakers or myself.
Thx
This should help clarify:
yes!! Lovely.
Also worth clarifying that the extra soundproofing batting goes on top of the existing batting.
Thx
Hah just got some quiet time away from the family, finished the duo v2 install. Found the mic, drug out the 100lbs subs and set them for auto cal, reran 8 measurements of 11 channels, fixed dampening/rumble settings on subs, further level matched all channels to preference........ Only to log on today and see I installed the V2 port foam incorrectly.
I laid them flat and pressed all the way down, I guess in my mind slowing the airflow like the S1 port dampers did rather than making a more narrow port channel.
At this point, no idea how to fish them out without damaging the cabinet and not spending the time and effort to recalibrate. Guess I have 'sealed' center channel now 🤷
The diagram helps a lot, I didn't understand the arrows either, but it now makes sense.
We would be happy to correct this for you if you want to ship the speakers back to us. Or, you can simply purchase extra long needle nose pliers which should work to get the dampeners out without issue:
We use this exact same tool: https://www.amazon.com/Dykes-Needle-.../dp/B0733NWRCS