wall mount for Luna

[Bruce Watson]

Thinking about a Luna pair for surrounds. For my HT room, I'd need a decent wall mount that would let me tilt them down a little, and rotate them a little. This is due to a doorway being in the wrong place (as it has been since 1962 I believe -- why don't builders plan ahead? ), and a high backed couch from the 1980s (this, I should just replace, but I'd rather spend the money on a Luna pair!).

So, the Lunas are smaller than the Sierras. I'd like to go with a smaller wall mount that'll get the speakers closer to the wall (Lunas have front ports so don't need wall clearance, yes?).

It's early days for the Luna I know. But has anyone got any suggestions for wall mounts for these little guys yet?

[Mahawkma]

Check out Dave's suggestion in the Luna thread.

[Bruce Watson]

Check out Dave's suggestion in the Luna thread.

I crawled through much of that thread; didn't see that though, so thanks.

I'm actually looking for something that will put the speaker closer to the wall. But if that single threaded insert is the only mounting point, that may be... difficult. Hmmm....

[racrawford65]

How about something like this?

Let's you tilt & rotate. You could probably slide the speaker pretty far back so it's close to the wall, as well.

https://www.amazon.com/dp/B01GISALQK...=2QRGK03YIR1PZ

[davef]

I crawled through much of that thread; didn't see that though, so thanks.

I'm actually looking for something that will put the speaker closer to the wall. But if that single threaded insert is the only mounting point, that may be... difficult. Hmmm....

The Luna's have a single threaded insert and an integrated keyhole bracket. The keyhole bracket is used to simply hang the speaker on a woodscrew or nail for flush mounting.

Please see the picture in this post:

http://forum.ascendacoustics.com/sho...6672#post56672

Thanks!

[Bruce Watson]

The Luna's have a single threaded insert and an integrated keyhole bracket. The keyhole bracket is used to simply hang the speaker on a woodscrew or nail for flush mounting.

Yeah. As I said in the OP, I need to be able to turn and tilt, so flush mounting isn't going to work for at least one pair of these.

Please see the picture in this post:

http://forum.ascendacoustics.com/sho...6672#post56672

Same reference as Post #2 above. And like I responded to that one, I was (am) hoping for something that gets me closer to the wall.

Ah well, it's still early days. Maybe someone will come up with something. Or I can put in the effort and make one that does what I want. It's just that I'm so damn lazy these days....

[davef]

Yeah. As I said in the OP, I need to be able to turn and tilt, so flush mounting isn't going to work for at least one pair of these.



Same reference as Post #2 above. And like I responded to that one, I was (am) hoping for something that gets me closer to the wall.

Ah well, it's still early days. Maybe someone will come up with something. Or I can put in the effort and make one that does what I want. It's just that I'm so damn lazy these days....

Please keep in mind that if you want to angle / tilt the speaker, there must be enough clearance behind the speaker to allow for the tilt.

The bracket I recommended places the speaker at only 2.5" from the wall, and thus allows for a decent amount of tilt in any direction. I don't think you will find a bracket with the options you need that will place the speaker closer to the wall.

I have attached a pic.