Quote Originally Posted by eliwankenobi View Post
Hello!

I hope DaveF or somebody from Ascend can answer this.

Is there a specific torque specification for tightening the screws?

I see in the video that the screws are tightened with a torque screw driver and also have one and would like what would be the specific in-lb setting so as to get them as close to factory as possible..

Thanks
Mag is correct,

It really comes down to a feel as torque settings from one driver to another vary considerably. Use a low torque setting and then tighten by hand. the bamboo is much tougher than MDF, more than likely you will break a head off a screw before you over tighten and ruin the screw threads in the bamboo.