-
Finished building my Millett Hybrid headphone amp
I finally sat down and built my Millett Hybrid headphone amp this week/weekend. I'm pretty happy with how it turned out:
Pre-casing:
All wrapped up:
BTW: The orange glow isn't just the tubes, I have orange power indicator LEDs under the tube sockets to increase the effect.
-
Wow Brad!!
That looks very nice! How many hours did it take you to build?
-curtis
-
Thanks Curtis. I don't really know how many total hours it took. It's a pretty easy build and I'm using an off-the-shelf power supply, so I didn't have to build it.
-
I see some solder....so I figure some of that was involved.
Just did a quick google and see that you can buy the board, but is there somewhere you can buy the entire kit? I also see that a fully built amp sells for $650!
-curtis
-
This is the place for info on the MH: http://www.diyforums.org/
If you stick to standard parts, it's about $70-80 for the board and components. Then there's the cost of the case and jacks, probably another $30+. Power supply can be anything from $12 (cheap wall wart) to $80 (fully populated STEPS power supply). In the end, at least $150 in parts total, much higher if you go with fancy stuff in fancy cases.
There aren't any full kits available that I know of, but that website has a bill of materials that includes part numbers from both digikey and mouser. If you're interested in building one, I can help you with picking or ordering parts.
-
You just gave my Audio Alchemy and I an inferiority complex. Thanks, Brad.
Nice work.
David
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules