I am getting conflicting advice on how to setup this speaker combination with the 635.
Before I ran EasySet, I configured it as follows:
All speakers set to small
Subwoofer set to 10 inches, on
Crossover in receiver used, VTF-2 MK 2 set to "out"
All speaker crossovers set to 80hz and LFE set to 80hz too
When I run the auto eq, it sets all speakers to large with 40hz crossovers for the speakers and 100-120hz (not sure if I remembered correctly) for the sub.
I know I can edit things but I am not sure what they should be. I read, on this forum, that the LFE should be set the same as the main speakers (80) but Dolby's 'standard' for LFE explosions is 120hz and that is exactly what is stated in the manual as well.
So what's the story?