Sierra-2EX upgrade question about damping material safety
Ok, so this might be in the OCD category, but I am going to ask anyway.
Just did the Sierra-2 to Sierra-2EX upgrade this morning and I noticed the crossover assembly has a new layout. When re-inserting the damping material in the woofer cavity, it is near impossible to prevent some of the material brushing up against some of the crossover components, such as a couple of copper coils. I assume the material is non-conductive, but does the crossover generate enough heat to be of concern with the damping material?
Re: Sierra-2EX upgrade question about damping material safety
Quote:
Originally Posted by
loafer
Ok, so this might be in the OCD category, but I am going to ask anyway.
Just did the Sierra-2 to Sierra-2EX upgrade this morning and I noticed the crossover assembly has a new layout. When re-inserting the damping material in the woofer cavity, it is near impossible to prevent some of the material brushing up against some of the crossover components, such as a couple of copper coils. I assume the material is non-conductive, but does the crossover generate enough heat to be of concern with the damping material?
Loafer,
Great question, but IMHO believe we are all in the clear! Not only is the damping material non-conductive and fire resistant, but the coils (LP) and caps (HP) are frequency dividers, not resistors that absorb power and convert it to heat!
Ted
Re: Sierra-2EX upgrade question about damping material safety
Yep, these speakers are hot, but in a good way! I believe the damping material they use currently is polyfill, first generation of cabinets used fiberglass in netting that was glued to the interior.
Jay
Re: Sierra-2EX upgrade question about damping material safety
Thank you both for your replies. This is great news! Now I don't have to remove 5 woofers and try to do the impossible by repacking the filling! Seriously, the upgrade instructions were good. I watched the installation videos before attempting the first upgrade, which was also helpful. Regards
Re: Sierra-2EX upgrade question about damping material safety
Quote:
Originally Posted by
loafer
Ok, so this might be in the OCD category, but I am going to ask anyway.
Just did the Sierra-2 to Sierra-2EX upgrade this morning and I noticed the crossover assembly has a new layout. When re-inserting the damping material in the woofer cavity, it is near impossible to prevent some of the material brushing up against some of the crossover components, such as a couple of copper coils. I assume the material is non-conductive, but does the crossover generate enough heat to be of concern with the damping material?
Hi Loafer,
The crossover in a speaker does not get hot, nowhere near hot enough to melt or cause damage to the damping material. In fact, with many sealed speakers (no ports) the enclosure is fully stuffed with loose damping material that often fully covers the crossover.
